首页分享济南导轨式升降机厂家谈安全装置如何安装？

济南导轨式升降机厂家谈安全装置如何安装？

来源：花匠小妙招时间：2025-11-18 23:10

#导轨式升降机#

　　1、导轨式升降机厂家介绍在基础吊笼处周围应设置高度不低于1.5m的防护围栏,且基础周围应有排水设施。

　　1. The manufacturer of the guide rail elevator introduces that a protective fence with a height of no less than 1.5m should be set up around the basic suspension cage, and there should be drainage facilities around the foundation.

济南导轨式升降机厂家谈安全装置如何安装？-有驾

　　2、导轨式升降机厂家谈到吊笼安全门宜采用连锁装置,升降台运行时安全]封闭吊笼的上料口,防止物料从吊笼中滚落。

　　2. The manufacturer of the guide rail elevator mentioned that the safety door of the suspension cage should be equipped with a chain device to ensure safety during the operation of the lifting platform. The loading port of the suspension cage should be closed to prevent materials from rolling off from the cage.

　　3、导轨式升降机厂家提醒平台上料口防护棚其宽度应大于导轨式升降机的最外部尺寸,其材料强度应能承受OkPa的均布静载荷。也可采用50mm厚木板或两层间距不小于600mm竹篱笆架设。

　　3. The manufacturer of the guide rail elevator reminds that the width of the platform loading port protective shed should be greater than the outermost dimension of the guide rail elevator, and its material strength should be able to withstand a uniformly distributed static load of OKPa. 50mm thick wooden boards or bamboo fences with a spacing of no less than 600mm can also be used for installation.

济南导轨式升降机厂家谈安全装置如何安装？-有驾

　　4、导轨式升降机厂家提醒断绳保护装置应安全可靠,尤其是弹筒式断绳保护器应注意润滑,防止套管与管内伸缩的圆钢销杆锈蚀。在升降台断绳后的瞬间压簧将销杆弹出，卡在导轨架的横腹杆上,防止吊笼坠落。

　　4. The manufacturer of the guide rail elevator reminds that the rope breakage protection device should be safe and reliable, especially the bullet type rope breakage protection device should pay attention to lubrication to prevent rust on the sleeve and the round steel pin rod that retracts inside the pipe. At the moment when the rope is broken on the lifting platform, the spring will pop out the pin rod and clamp it onto the crossbeam of the guide rail frame to prevent the cage from falling.

　　5、导轨式升降机厂家谈到各楼层进出料口处的作业非常危险,必须在各楼层口设置常闭的层门;宜采用连锁装置,门宜为1.8m ,门应设置在楼道口，与架体保持-段距离。导轨式升降机操作处应有开车示警声响信号和良好的全方位观察视野,賭量应能使各楼层使用导轨式升降机装卸物料人员清晰听到,其视野能够保证随着龙门]架的升高,导轨式升降机机操I能观察到每层进出料口处的作业情况。紧急断电开关应设在便于机操工操作的位置,在紧急情况下,应能及时切断导轨式升降机的总控制电源,避免事故的发生。

　　5. The manufacturer of the guide rail elevator mentioned that the operation at the inlet and outlet of each floor is very dangerous, and it is necessary to set up normally closed landing doors at each floor entrance; Chain devices should be used, and the door should be 1.8m long. The door should be set at the entrance of the corridor and maintain a certain distance from the frame. The operation area of the guide rail elevator should have a driving warning sound signal and a good all-round observation view. The gambling volume should be able to make it clear for personnel using the guide rail elevator to hear when loading and unloading materials on each floor. Their field of view should ensure that as the gantry rises, the guide rail elevator operator can observe the operation situation at the inlet and outlet of each floor. The emergency power off switch should be located in a position that is convenient for machine operators to operate. In emergency situations, it should be able to timely cut off the main control power supply of the guide rail elevator to avoid accidents.